Mobile Use; Setting Up For Noninvasive Use - ResMed C28173 Manual

248476r4.book Seite 13 Freitag, 28. Oktober 2011 3:10 15

Mobile use

The Stellar Mobility bag allows the Stellar to be used in mobile situations, eg, in a wheelchair. For
setup and correct use, see the Stellar Mobility Bag User Guide. For extended mobile use, the
ResMed Power Station II external power supply unit can be used as an additional power source.
Limitations apply to the use of oxygen with the Stellar Mobility Bag. For more information,
contact your local ResMed representative.

Setting up for noninvasive use

WARNING
The air filter cover protects the device in the event of accidental liquid spillage onto the
•
device. Ensure that the air filter and air filter cover are fitted at all times.
Make sure that all the air inlets at the rear of the device and under the device and vents
•
at the mask or at the leak port are unobstructed. If you put the device on the floor, make
sure the area is free from dust and clear of bedding, clothes or other objects that could
block the air inlets.
Hoses or tubes must be non-conductive and antistatic.
•
Do not leave long lengths of the air tubing or the cable for the finger pulse sensor
•
around the top of the bed. It could twist around the patient's head or neck while
sleeping.
CAUTION
Be careful not to place the device where it can be bumped or where someone is likely
•
to trip over the power cord.
Make sure the area around the device is dry and clean.
•
Notes:
ResMed recommends using the AC power cord supplied with the unit. If a replacement
•
power cord is required, contact your ResMed Service Centre.
Place the device on a flat surface near the head of the bed.
•
1
AC locking clip
AC power cord
1
Connect the power cord.
2
Plug the free end of the power cord into a power outlet.
3
Attach the H4i heated humidifier to the front of the Stellar 150.
If the H4i is not in use, and if applicable, connect the antibacterial filter firmly onto the air outlet
of the device (see "Attaching an antibacterial filter" on page 20).
2
3
4
Setting up for noninvasive use
5
13