Section 4 − Operation; Controls - Hobart Handler 190 Technical Manual

4-1. Controls

4
1 Wire Speed Control
Use control to select a wire feed speed. As
Voltage switch setting increases, wire
speed range also increases (see weld
setting label in welding power source or
Section 4-2, as applicable).
2 Power Switch
TM-260 273 Page 16
SECTION 4 − OPERATION
1
3
3 Voltage Switch
The higher the selected number, the
thicker the material that can be welded
(see weld setting label in welding power
source or Section 4-2, as applicable). Do
not switch under load.
.
Switch must "click" into detent
position.
2
5
4 Gun Trigger Receptacle
5 Trigger Switch
When pressed, energized wire feeds and
shielding gas flows.
Ref. 248 840-A / Ref. 246 668-A
Handler 190