Table of Contents
Advertisement
Positioning the Seat
Move the seat forward or backward as shown in
Figure
20.
Figure 20
Adjusting the
Motion-Control Levers
Adjusting the Height
You can adjust the motion-control levers higher or
lower for maximum comfort
Figure 21
g027249
(Figure
21).
g027252
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1.
Loosen the upper bolt holding the control lever
to the control-arm shaft.
2.
Loosen the lower bolt just enough to pivot the
control lever forward or rearward
3.
Tighten both bolts to secure the control lever in
the new position.
4.
Repeat the adjustment for the other control lever.
Pushing the Machine by
Hand
Important:
Always push the machine by hand. Do
not tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and
to push the machine, turn the ignition key to the
R
position. The battery needs to be charged and
UN
functioning to disengage the electric brake.
Pushing the Machine
1.
Park the machine on a level surface and
disengage the blade-control switch.
2.
Move the motion-control levers outward to the
P
position, shut off the engine, and wait
ARK
for all moving parts to stop before leaving the
operating position.
3.
Locate the bypass levers on the frame on both
sides of the engine.
4.
Move the bypass levers forward through the key
hole and down to lock them in place
Note:
Do this for each lever.
5.
Move the motion-control levers inward to the
N
position and turn the ignition key to the
EUTRAL
R
position.
UN
Note:
Do not start the machine.
Note:
You can now push the machine by hand.
25
(Figure
21).
(Figure
22).
Advertisement
Table of Contents
