Table of Contents
Advertisement
Service
Safe Handling of Gasoline
To avoid personal injury or property damage, use
extra care when handling gasoline and other fuels.
They are flammable and the vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
•
Use only an approved container.
•
Never remove the fuel cap or add fuel when the
engine is running. Allow the engine to cool before
refueling.
•
Never refuel the machine indoors.
•
Never store the machine or fuel container inside
where there is an open flame, such as near a
water heater or furnace.
•
Never fill containers inside a vehicle or on a
truck or trailer with a plastic liner. Always place
containers on the ground away from your vehicle
before filling.
•
Remove fuel-powered equipment from the truck
or trailer and refuel it on the ground. If this
is not possible, then refuel such equipment
with a portable container rather than from a
gasoline-dispenser nozzle.
•
Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times until the
fueling is complete. Do not use a nozzle lock-open
device.
•
If you spill fuel on clothing, change your clothing
immediately.
•
Never overfill the fuel tank. Replace the fuel cap
and tighten it securely.
General Service
•
Never operate a machine inside a closed area.
Engine exhaust contains carbon monoxide, which
is an odorless, deadly poison that can kill you.
•
Keep nuts and bolts tight, especially the blade
attachment bolts. Keep equipment in good
condition.
•
Never interfere with the intended function of a
safety device or to reduce the protection provided
by a safety device. Check their proper operation
regularly.
•
Keep the machine free of grass, leaves, or other
debris buildup. Clean up oil or fuel spills and
fuel-soaked debris. Allow the machine to cool
before storing it.
•
Stop and inspect the equipment if you strike an
object. Repair, if necessary, before restarting the
machine.
•
Never make any adjustments or repairs with the
engine running.
•
Grass catcher components are subject to wear,
damage, and deterioration, which could expose
moving parts or allow objects to be thrown.
Frequently check components and replace them
with the manufacturers' recommended parts, when
necessary.
•
Mower blades are sharp and can cut. Wrap the
blade(s) or wear thickly-padded gloves and use
extra caution when servicing them.
•
Check for proper brake operation frequently.
Adjust and service as required.
•
Maintain or replace safety and instruction decals
as necessary.
•
Use only genuine Toro replacement parts to
ensure that original standards are maintained.
Toro Riding Mower Safety
The following list contains safety information specific
to Toro products or other safety information that you
must know that may not be included in the ANSI
standards.
•
Stop the engine, move the motion-control levers
to N
and outward to the P
EUTRAL
disengage the blade-control switch, remove
key before and disconnect spark plug wire(s)
performing any service, repairs, maintenance or
adjustments.
•
Keep hands, feet, hair, and loose clothing away
from attachment discharge area, underside of
mower and any moving parts while engine is
running.
•
Do not touch equipment or attachment parts which
may be hot from operation. Allow to cool before
attempting to maintain, adjust or service.
•
Battery acid is poisonous and can cause burns.
Avoid contact with skin, eyes, and clothing. Protect
your face, eyes, and clothing when working with a
battery.
•
Battery gases can explode. Keep cigarettes,
sparks, and flames away from the battery.
•
Use only Toro approved attachments. You may
void the warranty if you use the machine with
unapproved attachments.
•
If loading the machine onto a trailer or truck, use
a single, full-width ramp only. The ramp angle
should not exceed 15 degrees.
6
position,
ARK
Advertisement
Table of Contents
