Stopping The Engine; Driving The Machine - Toro TimeCutter SS 4250 Operator's Manual

Stopping the Engine

1. Disengage the blades by moving the
blade-control switch to the O
13).
2. Move the throttle lever to the F
3. Turn the ignition key to the O
remove the key.

Driving the Machine

The drive wheels turn independently, powered by
hydraulic motors on each axle. You can turn 1 side
in reverse while you turn the other forward, causing
the machine to spin rather than turn. This greatly
improves the machine maneuverability but may
require sometime for you to adapt to how it moves.
WARNING
The machine can spin very rapidly. You
may lose control of the machine and cause
personal injury or damage to the machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Set the
throttle control in the F
For most applications, operate the machine in the
full-throttle position.
position
FF
position.
AST
position and
FF
position for performance.
AST
(Figure
1. Park (brake) position
2. Center, unlock position
3. Forward
21
Figure 14
4. Backward
5. Front of the machine
g004532