Table of Contents
Advertisement
Stopping the Machine
To stop the machine, move the motion-control
levers to N
and outward to the P
EUTRAL
disengage the blade-control switch, ensure that the
throttle is in the F
position, and turn the ignition
AST
key to O
. Remove the key from the ignition switch.
FF
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while
it is unattended.
Always remove the ignition key and move
the motion-control levers outward to the
P
position when leaving the machine
ARK
unattended, even if just for a few minutes.
Adjusting the Height-of-Cut
Note:
The transport position is the highest
height-of-cut position at 115 mm (4-1/2 inches) as
shown in
Figure
18.
Figure 18
Adjusting the Anti-Scalp
Rollers
position,
ARK
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
do not touch the ground in normal, flat mowing areas.
1.
2.
3.
1. Anti-scalp roller
2. Bolt
g027504
24
Adjust the anti-scalp rollers so that the rollers
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Adjust the anti-scalp rollers as shown in
19
to match the closest height-of-cut position.
Figure 19
-
EUTRAL
LOCK
Figure
g010233
3. Flange nut
4. Hole spacing
Advertisement
Table of Contents
