Advertisement
This manual is intended to assist the installer and
service personnel in the installation, operation, and
maintenance procedures to be performed on the
Beverage Control Panel Assembly (see Figure 1 and
applicable Figure 3, 4, 5, or 6).
The Beverage Control Panel Assembly is designed
to filter, pressure regulator, and distribute plain and
carbonated water, CO
gas, and syrup to the
2
Post–Mix Beverage Dispenser or dispensers and
various other equipment connected to the system.
NOTE: The Beverage Control Panel Assembly is
manufactured in America and has American
sizes on the hardware. All metric conversion are
approximate and vary in size.
NOTE: The Beverage Control Panel Assembly
was thoroughly inspected before leaving the
factory and the carrier has accepted and signed
for it. Any damage or irregularities should be
noted at the time of delivery (or not later than 15
days from date of deliver) and immediately
reported to the delivering carrier. Request a
written inspection report from Claims Inspector
to substantiate any necessary claim. File claim
with the delivering carrier, not with IMI Cornelius
Inc.
INSTALLING POST–MIX DISPENSER(S)
Refer to manual(s) provided with the Post–Mix
Dispenser(s) for installation instructions, then install
Dispenser(s) in operating location(s).
INSTALLING BEVERAGE CONTROL
PANEL ASSEMBLY
Your Beverage Control Panel Assembly may be
equipped with one or more of the optional kits as
shown in Figure 2. Figure 1 shows the standard
Beverage Control Panel Assembly with no optional
kits and Figure 2 shows the panel assembly with
optional kits installed.
NOTE: A dedicated and properly grounded
electrical outlet with proper electrical
requirements must be located close to the
Beverage Control Panel Assembly installation
location to provide electrical power to
(depending upon Beverage Control Panel Model
Number) one or two carbonators.
INSTALLATION
If your Beverage Control Panel Assembly is
equipped with either or both the optional air
compressor kit or the water pressure booster kit,
dedicated properly grounded electrical outlets with
proper electrical requirements must also be located
close to the Beverage Control Panel Assembly
installation location to provide electrical power.
No other electrical equipment should be connected to
these electrical circuits. ALL ELECTRICAL WIRING
MUST CONFORM TO NATIONAL AND LOCAL
ELECTRICAL CODES.
Item
No.
1
300894–000
2
300893–000
3
300912
4
311304
5
0590
INSTALLING WATER SURGE TANK (ITEM 1)
ON BEVERAGE CONTROL PANEL
ASSEMBLY
NOTE: It is suggested for ease of assembly, that
the loose–shipped WATER SURGE TANK (item 1)
be installed on the Beverage Control Panel
Assembly upper frame before the Panel
Assembly is set upright and fastened to the wall.
1. Install ELBOW ASS'Y SURGE TANK (item 5) in
top of WATER SURGE TANK (item 1) as shown
in Figure 17. Seal pipe thread connection with
pipe sealing compound.
2. Refer to applicable Figure 1 or 2 for water surge
tank location on Beverage Control Panel
Assembly upper frame, then remove two
self–drilling screws from frame.
3. Position water surge tank in position on
Beverage Control Panel Assembly.
4. Place STRAP, SURGE TANK (item 2) in
position around water surge tank and align
holes in strap with holes in frame where two
self–drilling screws were removed.
5. Secure strap to frame with two self–drilling
screws removed in step 2) preceding.
4
Table 2. Loose-Shipped Parts
Part No.
Name
Water Surge Tank
Strap, Surge Tank
Tube Ass'y, .375 I.D.
By 56–in long
Tapered Gasket,
Black
Elbow Ass'y, Surge
Tank
Qty.
1
1
1
4
1
0713
Advertisement
