Table of Contents
Advertisement
USER'S MANUAL OF WLAN BROADBAND ROUTER
Enable Dynamic Mode Click the checkbox to enable Dynamic PPTP function.
IP Address
Subnet Mask
Server IP Address
Server Domain Name
User Name
Password
Connection Type
Idle Time
MTU Size
Request MPPE
can use embedded PPTP client supported by this router to
make a VPN connection.
If you select the PPTP support on WAN interface, fill in
the IP address for it.
If you select the PPTP support on WAN interface, fill in
the subnet mask for it.
Enter the IP address of the PPTP Server.
Input domain name to resolve DHCP server.
If you select the PPTP support on WAN interface, fill in
the user name and password to login the PPTP server.
If you select the PPTP support on WAN interface, fill in
the user name and password to login the PPTP server.
Select the connection type from pull-down menu. There
are Continuous, Connect on Demand and Manual three
types to select.
Continuous connection type means to setup the
connection through PPTP protocol whenever this WLAN
Broadband Router is powered on.
Connect on Demand connection type means to setup the
connection through PPTP protocol whenever you send
the data packets out through the WAN interface; there are
a watchdog implemented to close the PPTP connection
while there are no data sent out longer than the idle time
set.
Manual connection type means to setup the connection
through the PPTP protocol by clicking the Connect
button manually, and clicking the Disconnect button
manually.
If you select the PPTP and Connect on Demand
connection type, fill in the idle time for auto-disconnect
function. Value can be between 1 and 1000 minutes.
Fill in the mtu size of MTU Size. The default value is
1460. Refer to 4.23 What is Maximum Transmission Unit
(MTU) Size?
Click the checkbox to enable request MPPE encryption.
Version: 1.0
37
Advertisement
Table of Contents
