SATO Argox XM4 Series User Manual page 50

XM4 Series Printer
User Manual
14. Lab Len (Top to Top)
For non-continuous media, it is the length between the tops of two labels.
15. Speed
The speed of printing. The unit is inch per second (ips).
16. Darkness
The current darkness.
17. Print Method
It is either thermal transfer (TT) or direct thermal (DT) printing. TT requires
ribbons and DT doesn't.
18. Print Length
The total print length.
19. Cut Count
It counts the times the cutter cuts.
20. RS232 Protocol
It lists RS-232C settings in the following order: baud rate, data length, parity
check, stop bit and flow control.
21. Code page
The character set table.
22. Media
The media type in use.
23. Calibration mode
There are intelli mode or smart mode.
Intelli mode: Just install labels, latch print module, press FEED button once,
and then the printer will feed 1-2 labels to detect next gap / black mark
before printing. The printer will feed 1-2 labels automatically before
printing, if FEED button is not pressed.
Smart mode: Print from the first label immediately according to label length
setting. Make sure to carefully align label bottom edge at the tear-off
position before printing.
45