View And Edit Communications Settings Menu - Extron electronics ISS 608 User Manual

Factory Reset
Reset the ISS to the default values. This reset is the same as the ZXXX reset via SIS
commands (see
Press and hold the NEXT button. The LCD window displays Factory Reset Please
•
Wait while the unit is resetting. When the reset is complete, release the NEXT button.

View and Edit Communications Settings Menu

Figure 20 is an overview of both the View User
Comm Settings and the Edit User Comm
Settings menus, the submenus, and the
available settings.
The default menu is View Comm Settings and
all of the submenus are display only, unable to
be edited. To access the Edit Comm Settings
menu and submenus, press and hold the NEXT
button until the menu changes to Edit Comm
Settings. Release the NEXT button.
Serial Port
The read-only Serial Port submenu displays
the baud rate of the ISS rear panel RS-232
port. This is a read-only submenu in both the
View Comm Settings menu and the Edit Comm
Settings menu (see
on page 57 to configure via SIS commands).
MAC Address display
The read-only MAC Address display shows the
hardcoded, factory assigned hardware address.
This is a read-only submenu in both the View
Comm Settings menu and the Edit Comm
Settings menu.
DHCP Mode
The DHCP Mode submenu displays the on or off status of the Dynamic Host Configuration
Protocol (DHCP) method of IP addressing. If DHCP is on, the switcher ignores any entered
IP addresses and obtains its IP address from a DHCP server (only if the network is DHCP
capable).
From the Edit Communications Settings menu, rotate either ADJUST knob to select DHCP
Mode. Options are ON or OFF (default).
Soft reset on page 57).
Serial port configuration
ISS 608 and ISS 612 Seamless Switchers • Operation
NEXT NEXT
View Comm
Setting
Press and hold
Menu
NEXT
NEXT to edit fields
Serial Port
9600 RS232
View the baud rate of
NEXT
Menu the RS-232 port
MAC Address
0005A6003C24
View factory set
NEXT
MAC address
Menu
DHCP Mode
Off
Rotate to select
NEXT
or
On or Off
Menu
IP Address
192.168.254.254
Rotate
NEXT
&
Rotate to change address
Menu
Subnet Mask
255.255.0.0
Rotate
NEXT
&
Menu
Rotate to change address
Gateway Address
0.0.0.0
Rotate
&
NEXT Rotate to change address
Menu
Figure 20. View and Edit
Communication Settings
Menu
Exit Menu?
Press Next
to select octet field
to select octet field
to select octet field
28