Transferring Bank Contents - Icom ID-800H Instruction Manual

5
MEMORY OPERATION

■ Transferring bank contents

Contents of programmed memory banks can be cleared or
transferred to another bank.
INFORMATION: Even if the memory bank contents are
cleared, the memory channel contents still remain pro-
grammed.
q Select the desired bank contents to be transferred or
erased.
➥ Push [M/CALL•PRIO] several times to select memory
mode.
➥ Push [BAND] then rotate [DIAL] to select the desired
memory bank.
• Bank's initial blinks.
➥ Push [BAND] to select the bank then rotate [DIAL] to se-
lect the desired contents.
• Bank's initial stops blinking.
w Push [SET•LOCK] to enter set mode.
• Rotate [DIAL] to select "SET," if necessary.
e Push [SET•LOCK] or [S.MW•MW] several times until
"BAK" appears.
• The bank's initial for the selected memory channel is displayed.
37
[
rRotate [DIAL] to select the desired bank initial to transfer
or erase.
• Select "-- --" indication when erasing the contents from the bank.
t Push [V/MHz•PRIO] to set the bank and exit set mode.
y Repeat steps q to r for transferring or erasing an an-
other banks contents.
BANK
SET
[Y]/[Z]
z Select the desired bank contents to be trans-
ferred or erased.
➥ Push [MR/CALL] to select memory mode.
➥ Push [FUNC], [
1(BANK)] then select
MONI
the desired memory bank via [Y]/[Z].
➥ Push [
A(MW)] to select the bank then
CLR
select the desired contents via [Y]/[Z].
x Push [
B(D-OFF)] to enter set mode.
SET
• Push [Y] or [Z] to select "SET," if necessary.
c Push [
B(D-OFF)] or [
SET ENT
times until "BAK" appears.
v Push [Y]/[Z] to select the desired bank initial to
transfer or erase.
• Select "-- --" indication when erasing the contents
from the bank.
b Push [
A(MW)] to set the bank and exit set
CLR
mode.
n Repeat steps z to b for transferring or eras-
ing an another banks contents.
C(T-OFF)] several