Icom ID-800H Instruction Manual page 45

D Memory/call➪memory/call
q Select the memory/call channel to be transferred.
➥ Push [M/CALL•PRIO] several times to select memory
mode or call channel, then rotate [DIAL] or push [BAND]
to select the desired memory or call channel respec-
tively.
w Push [S.MW•MW] momentarily.
• "!" indicator and "-- -- --" indication blink, and shows VFO con-
ditions.
e Rotate [DIAL] to select the target memory channel.
• "C1" or "C2" blinks when the call channel is selected.
• Scan edge channels, 1A/1B, 2A/2B, 3A/3B, 4A/4B, 5A/5B can
also be selected.
r Push [S.MW•MW] for 1 sec. to transfer the selected mem-
ory/call channel contents to the target memory.
• The targeted memory and transferred contents are indicated.
[EXAMPLE]: Transferring memory channel 30 contents to channel 31.
Front panel operation:
Select the memory channel, then push
HM-133 operation:
Select the memory channel, push
MR/CALL
MW
[Y]/[Z]
BAND
. Select the target channel.
then push .
MEMORY OPERATION
z Select the memory/call channel to be trans-
ferred.
➥ Push [MR/CALL] to select memory mode,
then select the desired memory channel
via [Y]/[Z] or keypad.
➥ Push [MR/CALL] for 1 sec. then push
[BAND] to select the desired call channel.
x Push [FUNC], then [
A(MW)] momentarily.
CLR
• "!" indicator and "-- -- --" indication blink, and
shows VFO conditions.
c Push [Y]/[Z] to select the target memory
channel.
• "C1" or "C2" blinks when the call channel is selected.
• Scan edge channels can also be selected.
• The keypad cannot be used for the selection.
v Push [FUNC] then push [
1 sec. to transfer the selected memory/call
channel contents to the target channel.
• The targeted channel and transferred contents
are indicated.
Push for 1 sec.
Push then push
5
5
A(MW)] for
CLR
for 1 sec.
30