Icom ID-800H Instruction Manual page 19

r AUTO POWER-OFF INDICATOR (p. 62)
Appears while the auto power OFF function is in use.
t AUDIO MUTE INDICATOR (P. 18)
Appears when the audio mute function is activated.
• The mute can only be switched ON and OFF from the HM-133
only.
y FREQUENCY READOUT
Shows the operating frequency, channel names, set mode
contents, etc.
• Frequency decimal point blinks while scanning. (p. 41)
• "d" appears in place of the 1st digit while the DTMF memory
function is in use. (p. 48)
u MEMORY INDICATOR (pgs. 11, 26)
Appears when memory mode is selected.
i WEATHER ALERT INDICATOR (p. 66)
Appears when the weather alert function is activated.
• The either alert function is available with the USA version only.
1 o PRIORITY INDICATOR (p. 47)
Appears while the priority watch is activated; blinks while
the watch is paused.
!0 MEMORY CHANNEL NUMBER INDICATORS
➥ Shows the selected memory channel number. (p. 26)
➥ Shows the selected bank initial. (p. 35)
➥ "C" appears when the call channel is selected. (p. 38)
➥ "L" appears when the lock function is activated. (p. 14)
!1 SKIP INDICATORS (p. 44)
➥ "~"appears when the displayed memory channel is
specified as a skip channel.
PANEL DESCRIPTION
➥ "P ~" appears when the displayed frequency is spec-
ified as a program skip frequency.
!2 SQUELCH ATTENUATOR INDICATOR (p. 16)
Appears when the squelch attenuator function is activated.
• The attenuator can be switched OFF in initial set mode. (p. 63)
!3 DIGITAL MESSAGE INDICATOR (p. 61)
Appears when a digital message is received.
!4 MODE INDICATORS
➥ No indication appears while in the FM mode operation.
(p. 65)
➥ "AM" appears while in the AM mode operation. (p. 65)
➥ "NAR" appears while in the FM/AM narrow mode oper-
ation. (p. 65)
➥ "DV" appears while in the digital mode operation. (p. ??)
• Blinking all indication indicates the FM mode selection while
setting.
!5 S/RF INDICATORS
➥ Shows the relative signal strength while receiving sig-
nals. (p. 15)
➥ Shows the output power level while transmitting. (p. 17)
!6 OUTPUT POWER INDICATORS
"LOW" appears when low output power; "MID" appears
when middle output power is selected.
No indicator appears when high output power is selected.
!7 BUSY INDICATOR
➥ Appears when a signal is being received or the squelch
is open. (p. 15)
➥ Blinks while the monitor function is activated. (p. 15)
1
1
4