Table of Contents
Advertisement
Setting the Speaker
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.Signal outputs
and frequency response from the speaker will automatically be adjusted according to your speaker configuration
and whether certain speakers are used or not.
REMOTE CONTROL
1
2
3
To Exit Setup Mode
Wait for about 5 seconds or press the SPK SEL. button of the remote control to
•
select SPK MODE OFF.
To Use SUBWOOFER button of Remote Control
Press SUBWOOFER button.
•
Each time you press this button, SW SPK : YES, SW SPK : NO will be selected in turn.
•
If you play in 2 Channel Stereo, select 'YES' to use Subwoofer and 'NO' not to use.
Caution!
•
If F.SPK is set to 'SMALL', SW SPK is fixed to 'YES'.
•
If S.SPK is set to 'NONE', SB SPK is fixed to 'NONE'.
•
You cannot use Speaker Setup Mode in 5.1CH MULTI CH function.
17
√
Press SPK SEL. button to select the speaker you want.
Each time you press this button, F.SPK
C.SPK
S.SPK
•
SW SPK
CROVR
SPK MODE OFF will be selected in turn.
Press ...† button to set the speaker as you want.
Repeat the steps 1 and 2 to set the speaker.
SB SPK
Setting the Speaker
• F.SPK (Front) : LARGE, SMALL
• C.SPK (Center) : LARGE, SMALL, NONE
• S.SPK (Rear) : LARGE, SMALL, NONE
• SB SPK (Rear Center) : LARGE, SMALL, NONE
• SW SPK (Subwoofer) : YES, NO
• CROVR (Crossover Frequency): 40, 60, 80, 100, 120, 150,200Hz
MAIN UNIT
1
Press and hold SURROUND button for about 5 seconds.
• "SETUP MODE" appears on the display and enters into Setup Mode.
2
Press INPUT button one time.
• "SPEAKER SETUP" appears in the display.
Press SURROUND button to select the speaker you want.
3
Each time you press this button, F.SPK
C.SPK
SPK SW SPK
CROVR will be selected in turn.
4
Press SELECT (
) button to set the speaker as you want.
,
Repeat the steps 3 and 4 to set the speaker.
5
To Exit Setup Mode
•
Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit.
"SETUP MODE OFF" appears on the display and exits Setup Mode.
• LARGE : Select when you use large speaker. You can listen to full
ranges of sound from bass to treble.
• SMALL : Select this when you use small speaker. Bass below
100ß' will not be output from the whole speakers but only
from subwoofer.
• NONE : Select this when you use no speaker.
• YES : Select this when you use Subwoofer Speaker if you play
back in 2 Channel Stereo.
• NO : Select when you do not use Subwoofer Speaker if you play
back in 2 Channel Stereo.
• CROVR: Select the crossover frequency depending on the size of
speaker connected when you use subwoofer. Select 40Hz
if cone paper speaker is 16cm, select 60Hz for 14cm,
80Hz for 12cm, 100Hz for 10cm, 12Hz for 8cm ,150Hz for
6cm and 200Hz for 4cm.
S.SPK
SB
18
Advertisement
Table of Contents
