Test Tone
Use test tone to check speaker connection status or defect of speaker or adjust the level.
To Automatically Output Test Tone
MAIN UNIT
1
2
3
To Stop Test Tone
Method 1) Press INPUT button 2 times.
"TEST-T OFF" appears on the display and test tone stops.
•
Method 2) Turn VOLUME CONTROL.
"SETUP MODE OFF" appears on the display and test tone stops.
•
23
√
Press and hold SURROUND button for about 5 seconds.
"SETUP MODE" appears on the display and enters into Setup Mode.
•
Press INPUT button 4 times.
"TEST-T AUTO" appears in the display.
•
Press SURROUND button.
Test signal will be automatically output as follows; F.L
CEN
•
S.L
S.W .
During test signal output, press SELECT (
) button to adjust the speaker output
•
,
level from -10 to +10 dB by 1 step.
F.R
S.R
S.B
Test Tone Output
F.L (Front-Left) : -10 ~ +10dB
•
CEN (Center) : -10 ~ +10dB
•
F.R (Front-Right) : -10 ~ +10dB
•
S.R (Rear-Right) : -10 ~ +10dB
•
S.B (Rear Center): -10 ~ +10dB
•
S.L (Rear-Left): -10 ~ +10dB
•
S.W (Subwoofer): -10 ~ +10dB
•
To Manually Output Test Tone
√
MAIN UNIT
1
Press and hold SURROUND button for about 5 seconds.
•
"SETUP MODE" appears on the display and enters into Setup Mode.
2
Press INPUT button 5 times.
•
"TEST-T MANU" appears in the display.
3
Press SURROUND button.
•
Each time you press this button, F.L
CEN
F.R
will be selected in turn.
4
Press SELECT(
)button to set the test tone as you want.
,
You can adjust the speaker output level from -10 to +10dB by 1 step.
•
To Stop Test Tone
Method 1) Press INPUT button 1 time.
"TEST-T OFF" appears on the display and test signal stops.
•
Method 2) Turn VOLUME CONTROL.
"SETUP MODE OFF" appears on the display and test tone stops.
•
Caution!
You cannot use test tone in 5.1CH MULTI CH function.
•
S.R
S.B
S.L
S.W
24