Table of Contents
Advertisement
Installation and Operation Guide SOLECTRIA
5.10.2
Static Routing, Entering Static Routing Rule on LAN
A static routing rule can be implemented on any permanently installed device on the LAN. Most commonly this
is configured on the Internet Gateway Modem/Router or the third-party DAS (if feature is provided).
To enter the static routing rule, the following information is required:
Destination Network:
•
o The Gateway Inverter Cluster IP Address. Obtained from the landing page of the GUI
MASK: Cluster LAN mask
•
o Determined by the IP address within the Cluster LAN. By default this is 255.0.0.0, but can be
more restrictive if custom inverter Cluster IPs are configured.
Gateway IP: Gateway Inverter External IP Address
•
o Listed as Active LAN IP on the Modbus Access Configuration page, see Figure 5-8
The method of entering static routing rules varies depending on the device or operating system, for more
information work with your IT professional.
Manage Cluster IP Address
The internal Cluster IP Address are automatically assigned to each XGI inverter at the factory. If desired the IP
address can be managed and statically assigned. Supported ranges include 10.0.021 – 10.255.255.254 &
192.168.0.21 – 192.168.0.254.
Internal Cluster IPs: In most applications the internal cluster IPs are only used for communication behind the
Gateway Inverters. Exceptions include: (1) utilizing Static Routing, and (2) when no gateway inverter is
configured (this is not recommended.)
Login to the inverter using the Admin credentials and navigate to Inverter Configurations Network
Configurations Advance Network Configurations Network Cluster Configurations. Select the check
box Manage cluster Ip addresses and edit the Cluster IPs as desired, see Figure 5-9.
Click Save to store the changes.
DOCR-071074 (Rev 7, 30 MAY 2023)
Figure 5-8 Enabling external Modbus access, static routing
®
XGI 1500-250 Series Inverters
NOTICE !
39 of 72
Advertisement
Table of Contents
