Monitoring The Displays; Displays; Figure 23 - Display Formats With The Process Variable; Table 26 - Displays With Pv Format Display Indications - Honeywell SMV800 SmartLine User Manual

9.4 Monitoring the Displays

This section describes the information shown on the operator screens of the Display.

9.4.1 Displays

As shown in Figure
Table 26 lists and describes the fields in each of the three Display formats. Essentially, all three
formats provide the same information, but with the following differences:
•
Bar Graph. User Configurable 126 segment Bar Graph with range settings. The Bar Graph
displays the current value of the configured PV.
•
PV Trend. User-configurable display period from one hour to 24 hours. The chart displays
minimum, maximum, and average of the configured PV over the selected trend period.
Display Indicator
Diagnostic / Maintenance
These indicators are displayed in the upper left
corner of the screen when the associated
conditions are present in the transmitter.
Page 60
23, the Display provides three formats.
Figure 23 – Display formats with the Process Variable
Table 26 – Displays with PV Format Display Indications
SMV800 Transmitter User's Manual
What It Means
D Diagnostic condition present
This indicator is displayed any time a
diagnostic is present in the transmitter,
either Critical or Noncritical. If a Critical
Diagnostic is present, the message
"Critical Diag" will flash at the top of the
screen and the appropriate Diagnostic
screen will be inserted into the normal
screen rotation.
To determine which Noncritical
diagnostics are active, use the local
buttons to access the Noncritical
diagnostics menu (Main
Menu\Diagnostics\Non-Critical. Refer
to Table 10 for details concerning the
Noncritical diagnostics.
Revision 10