Setting an indoor unit installation option with wired remote controller
In order to check and set the indoor unit installation option code use the wired remote controller and follow the directions
below.
1. Press the
and
2. Press the
/
button to select
3. Press the
/
button to select
screen.
• The first digit represents the page number and the remaining five digits are installation option.
NOTE
• The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
4. Press the
/
button to set the installation option code in order. Press
5. Press the
button to save and complete the option setting.
6. Press the
button to exit to normal mode.
• Press
NOTE
• Option code will not be applied if you don't press
• Setting Installation option code is available only with a master wired remote controller.
• Setting Installation option code is available when there is one on one connection between a wired
remote controller and an indoor unit.
Setting the indoor unit addresses
Option No. for an indoor unit address: 0AXXXX-1XXXXX-2XXXXX-3XXXXX
Before installing an indoor unit, be sure to set an address for the indoor unit by taking the following steps:
1. Make sure that the power is supplied to the indoor unit. If the
indoor unit is not plugged in, it must include a power supply.
2. Set an address for each indoor unit using the remote control, according to your air conditioning system plan, by referring to
the following table and by following the steps in "Common steps for setting the addresses and options" on page 40.
• The indoor unit addresses (main and RMC addresses) are set to 0A0000-100000-200000-300000 by default.
• If indoor units and outdoor units match 1:1, you don't need to set the main address because it is automatically set by the
outdoor unit.
DB68-11271A-02_IM_CAC Universal AHU Indoor_AA_EN_.indd 49
buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
and then press
and then press
button anytime during setup to exit without setting.
button to enter a Sub-menu setting screen.
button to enter a Indoor unit installation option code setting
button to go to the next page.
button.
1(L) 2(N)
F1
F2
V1
V2
F3
F4
English
49
2022-09-15 오전 9:53:33