Table of Contents
Advertisement
Installation Procedure
• Option code will not be applied if you don't press the
CAUTION
• Setting indoor unit option code is only possible in Master wired remote controller. You can only
check the indoor unit option code in Slave wired remote controller.
• Setting indoor unit option code is possible when one indoor unit is connected. If more than 2 indoor
units are connected, you can only check the Master indoor unit option code.
Set the indoor unit address and installation option with remote controller option. Set the each option separately since you
cannot set the ADDRESS setting and indoor unit installation setting option at the same time. You need to set twice when
setting indoor unit address and installation option.
Setting an indoor unit address with wired remote controller
1. Press the
and
2. Press the
/
button to select
3. Press the
/
button to select and then press
Data bit
1 2 34 56
• The Main/RMC Address which is currently setting will flicker.
• Data bit 1 and 2 present Indoor unit main address checking.
NOTE
• Data bit 3 and 4 present Indoor unit main address setting(outdoor unit reset is needed to set).
4. Press the
/
button to set the Indoor unit Main/RMC Address.
5. Press the
button to save and complete the option setting.
6. Press the
button to exit to normal mode.
• Press the
NOTE
• Address will not be applied if you don't press
• Setting Main/RMC Address of an Indoor unit is available only with a master wired remote controller.
48 English
DB68-11271A-02_IM_CAC Universal AHU Indoor_AA_EN_.indd 48
buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
and then press
button to enter a Indoor unit option code setting screen.
button to save and complete the option setting.
button to enter a Sub-menu setting screen.
button.
2022-09-15 오전 9:53:32
Advertisement
Table of Contents
