Samsung AC BNZDCH Series Installation Manual page 40

Installation Procedure
Setting the indoor unit addresses and
the installation options with wireless
remote controller
You cannot set both of the indoor unit addresses and the
installation options in a batch: set both of them respectively.
Receiver & display unit must be connected to the indoor
unit to set options with the wireless remote control.
Common steps for setting the addresses and
options
Remote controls
Entering the
mode for setting
the options
High Temp button
Low Temp button
• The remote control display and buttons
may vary depending on the model.
NOTE
1. Enter the mode for setting the options:
a. Remove the batteries from the remote control, and
then insert them again.
b. While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c. Make sure that you are entered to the mode for
setting the options:
40 English
DB68-11271A-02_IM_CAC Universal AHU Indoor_AA_EN_.indd 40
2. Set the option values.
CAUTION
Setting the
option values
Mode button
High Fan button
Low Fan button
SEG1
SEG7
SEG13
SEG19
(High Temp) and
• The total number of available options
are 24: SEG1 to SEG24.
• Because SEG1, SEG7, SEG13, and SEG19
are the page options used by the
previous remote control models, the
modes to set values for these options
are skipped automatically.
• Set a 2-digit value for each option pair
in the following order: SEG2 and SEG3
→ SEG4 and SEG5 → SEG6 and SEG8 →
SEG9 and SEG10 → SEG11 and SEG12 →
SEG14 and SEG15 → SEG16 and SEG17
→ SEG18 and SEG20 → SEG21 and
SEG22 → SEG23 and SEG24
SEG2 SEG3 SEG4
0 X X X
SEG8 SEG9 SEG10
1 X X X
SEG14 SEG15 SEG16
2 X X X
SEG20 SEG21 SEG22
3 X X X
On (SEG1 to SEG12) Off (SEG13 to SEG24)
SEG5 SEG6
X X
SEG11 SEG12
X X
SEG17 SEG18
X X
SEG23 SEG24
X X
2022-09-15 오전 9:53:25