Storing The Murphy Bed - Jayco JAY FEATHER Towables 2020 Owner's Manual

Section 12: Interior
Snap hooks (if present) must be attached to the steel rings on the sofa
arms before using the bed. Failure to attach these snap hooks to the steel
loops on the sofa can result in serious injury or property damage.
MAKE SURE THE SAFETY STRAPS AT EACH SIDE
OF THE FOOTBOARD ARE ATTACHED TO THE
STEEL LOOPS ON THE SOFA ARMS BEFORE PUT-
TING ANY WEIGHT ON THE BED.
The label shown here is located next to the slide out controls
inside the entrance door. It should not be removed.
NOTE: On some models, the Murphy bed may lock in place when
lowered to keep it from flipping up unexpectedly. In order to release
the bed, a lever must be pulled first. There are two types of levers.
One is a "T" handle installed in the side dresser and the other is a
lever built into the side of the couch. When the lever is pulled, the
bed can be returned to the folded or stored position. Make sure to
latch the sliding "D" bolts on each side when bed is returned to the
upright stored position.
Remove the straps holding the mattress to the bed frame by
unsnapping the two plastic buckles on top of the mattress.
These straps can be stored on the side of the mattress, or
tucked between the headboard and the mattress. Release the
mattress hook from the foot of the bed.

Storing the Murphy Bed

Attach the "Y" strap that holds the mattress to the
bedframe. Pull the straps with the buckles up from
the head of the bed and snap them to the "Y" strap.
Secure the snap hook at the footboard. MAKE
SURE THE SAFETY STRAPS AT EACH SIDE
OF THE FOOTBOARD ARE STILL ATTACHED
TO THE STEEL LOOPS ON THE SOFA ARMS
BEFORE PUTTING ANY WEIGHT ON THE
BED.
Unhook the safety strap snap hooks from the steel
loops on the arms of the sofa.
Release the locking lever (if applicable) so bed can
be raised.
Push the bed back up into the storage position.
156
