Jayco JAY FEATHER Towables 2020 Owner's Manual page 81

Table of Contents

Advertisement

8.
Release the OUT button when the room is fully extended or the IN button when fully
retracted, and stops moving.
Turn OFF the on/off switch or key.
9.
Fault Diagnostics / Troubleshooting
The control has the ability to detect and display several faults. When a fault is detected,
room movement stops and two different LEDs will flash in a pattern.
The RED FAULT CODE LED (Fig 4) will flash a number of times corresponding to a spe-
cific fault code (refer to the Fault Code Chart).
The GREEN ROOM MOVEMENT LED (Fig 4) will flash GREEN a number of times cor-
responding to which motor has the associated fault.
Example: (4) RED flashes and (2) GREEN flashes indicate a motor fault on motor 2.
MAJOR and MINOR faults; faults must be cleared for the room to operate normally.
MINOR faults can be cleared by pushing and releasing the IN or OUT buttons on
the wall touchpad (Fig 4).
MAJOR faults must be cleared by pushing and releasing the SET STOPS/CLEAR
FAULTS button located on the back of the wall touchpad (Fig 2).
NOTE: For MAJOR faults, the control must be overridden by
following the EMERGENCY RETRACT MODE in the OVERRIDE
MODES section.
Fault Codes
Fault
Fault
Type
Description
Code
Stops not
1
Major
programmed
2
Minor
System Fault
Excessive
4
Major
Battery Volt-
age
Section 5: Slideout Systems
Possible Cause
-Stops have not been
set
-Stops were cleared
-Stops were improperly
set
-Obstruction present
-Excessive system drag
-Bad or loose connec-
tion
-Defective harness
-Open or shorted motor
Possible Solution
Steps need to be programmed
by an authorized service
facility.
Run room in opposite direc-
tion. If it continues to move
in the opposite direction,
remove obstruction, exces-
sive weight in room or repair
of damaged component. If
room stops moving in op-
posite direction, observe fault
code and refer to this chart
-Check all connections at
control box and motor
-Check the harness for bro-
ken wires.
-Put 12.0 VDC direct to the
motor. If it does not run,
replace the motor.
79

Advertisement

Table of Contents
loading

Table of Contents