Jayco JAY FEATHER Towables 2020 Owner's Manual page 82

Section 5: Slideout Systems
6 Minor
Park brake LED flashing
Low voltage LED flashing
Preventative Maintenance
The Power Gear® slideout system requires very little maintenance. Read and follow these
procedures:
When the room is extended, visually inspect the slide rail assemblies. Check for
excess buildup of dirt or foreign material; remove any debris that may be present.
If the system squeaks or makes any noises, blow out any debris from the gear rack
arms and apply a dry lubricant to prevent and/or stop squeaking.
Refer to the Power Gear® website
Override Modes
In the event of component failure or loss of system power, your slideout can be manually
overridden and retracted for travel.
NOTE: During the override procedure, the unit will exit this mode
if the room has not been moved for two (2) minutes or if a fault is
detected during room movement. The Fault Code (RED) and Room
or Lock Movement (GREEN) LEDs will flash rapidly for 10 seconds to
indicate the override procedure failed. After 10 seconds of flashing,
the control will automatically default to FAULT CODE 1. Program-
ming must be restarted.
NOTE: After overriding the system, the room control will need to be
re-programmed by an OEM authorized dealer.
80
Supply voltage to con-
trol box is 17 0 V DC
or greater
-Parking brake not set
(if applicable)
-Ground signal lost at
park brake control
Incoming violated to
control box is below
12.0 VDC
www.powergearus.com
Check 2-pin power connector
at control box. If the voltage
is 17. VDC or higher, contact
O.E.M for power and ground
supplies
-Set parking brake (if ap-
plicable)
-Check for continuity to
ground on wire plugged
into park brake connector at
control box
Check 2-pin power connec-
tor at control box. If voltage
is below 12.0 VDC contact
O.E.M for power and ground
supplies.
for additional information.