Section 11: Electronics; Hdtv Antenna/Satellite System(S); Hdtv Antenna (If So Equipped); Antenna Power Supply (If So Equipped) - Jayco JAY FEATHER Towables 2020 Owner's Manual

HDTV Antenna/Satellite System(s)

HDTV Antenna (if so equipped)

Your recreation vehicle is equipped with an exterior fixed height high
definition TV antenna. This antenna rotates 360° and is capable of re-
ceiving any over-the-air (OTA) high definition television signals being
broadcast in your receiving area.
The enclosure base for the antenna (inside the RV on the ceiling) will
have a knob that can rotate a full 360° to adjust for the best signal com-
ing to the antenna. Your RV may have one of two types of antenna bases
mounted to the ceiling.
The first type has a button on the large knob that must be pressed
first to unlock it, so it can be turned. The button may have to be held
while rotating, and then once released, locks the antenna in position
(arrow on the knob indicates antenna direction).
The second type of antenna base has a large knob that must be
pushed upward to unlock the antenna. The knob can then be rotated
360° and when released locks the antenna in place.This antenna has
a travel position when you are ready to move your RV. Rotate the
handle clockwise (indicated by the arrow on the ceiling plate) until
the antenna hits a hard stop and will not rotate further. Turn off the antenna power supply.
Refer to the HDTV manufacturer's manual for detailed operating and safety information.
NOTE: A channel scan must be run to search for and tune in local
TV channels. This feature is built into each TV and is not the same
as pressing the channel up/down button on the TV remote control.
Your TV manual will explain how to perform a channel scan.
NOTE: The antenna is a fixed height (12" maximum) and cannot
be lowered or raised. Trees and foliage will interfere with receiving a
strong HDTV signal.

Antenna Power Supply (if so equipped)

For good station reception, the antenna power supply must be turned ON to
view local television stations. Turning the antenna power supply ON sends
12-volt DC through the cable to the TV roof antenna turning the antenna
amplifier ON. Over-the-air HDTV signals are then fed to the TV from the
antenna.
Turn the antenna power supply OFF to view cable television or to use the
DVD player. The ON/OFF switch is located on the wall plate for the antenna
connection. An LED will light to indicate antenna power is ON.

Satellite (if so equipped)

Please refer to the manufacturer's instructions for setup, care and maintenance.

Section 11: Electronics

Antenna Power
Supply
147