Table of Contents
Advertisement
3.
Remove the bed bow brace from the
ceiling by pushing in on the exposed
push-button and pulling down. Pull the
bed bow towards you and remove the
"claw" connector from the curved win-
dow bow. Set the bed bow brace aside.
4.
From the exterior, lift the bottom of the
tent up exposing the bed platform. Fold the tent in towards
the center of the bed platform.
Make sure the bed tent is pushed in at least 1" above the
5.
side bulb seal.
6.
Lift the bed up and hold it in a vertical position. Tuck the
tent in on both sides. Make sure the top of the door is clear
from obstructions.
7.
Latch one side of the door.
8.
From the interior, inspect the perimeter
of the door making sure there is noth-
ing obstructing the top and sides of
the door. Make sure the hinge cover is
clear of the door.
If the tent or hinge cover is not clear of the
door edges, the door will not close and seal
tightly, and/or damage to the bulb seal may
occur.
NOTE: If the bed does not close easily, inspect the bed cushion
from the sides looking for obstructions. Once the obstruction is
located, lower the bed board, correct the obstruction and try again.
9.
From the exterior, latch the other side of the door.
10. Place the bed bow brace inside the folded front
bunk mat.
11. Place the front bunk mat against the closed front
bed platform. Secure it in place by hooking the
canvas straps to the D-ring hasp located above the
bed shelf. If needed, adjust the straps to assure the
bunk mat is firmly secure against the bed platform.
Side Bed (if so equipped): Repeat steps 1 - 9.
10. Place the side bed bow brace in the folded FRONT bunk mat for storage.
Rear Bed: Repeat steps 1 - 9.
10. Place the rear bed bow brace in the folded FRONT bunk mat for storage. Store the
bunk mat between bed platform and the interior wall. You will need to slide one end in
first and bend the mat to secure it in place.
Section 4: Vehicle Operation
63
Advertisement
Table of Contents
