Solid-State Drive - Lenovo 30BH User Manual

Figure 77. Installing the hard disk drive into the bracket
7. Slide the new hard disk drive into the drive cage until it snaps into position.
Figure 78. Installing the secondary hard disk drive
8. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 100.

Solid-state drive

The solid-state drive is only available on some models.
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
Installing the solid-state drive
To install the solid-state drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Install the solid-state drive into the storage converter shipped with the solid-state drive. Then install the
four screws to secure the solid-state drive to the storage converter.
94
P320 User Guide