Table of Contents
Advertisement
Figure 51. Flexing both sides of the bracket to remove the 3.5-inch internal storage drive
4. Flex the bracket and align pins
3.5-inch internal storage drive. Then install a new 3.5-inch internal storage drive into the bracket. Do not
touch the circuit board
Figure 52. Installing the new 3.5-inch internal storage drive into the bracket
5. Slide the new 3.5-inch internal storage drive into the kit from the rear until the internal storage drive
snaps into position.
1
,
2
,
3
, and
4
on the bracket with the corresponding holes in the new
5
on the internal storage drive.
.
Chapter 7
Hardware removal and installation
79
Advertisement
Table of Contents
