Table of Contents
Advertisement
Figure 83. Installing the new solid-state drive into the storage converter
8. To install the storage converter into the 3.5-inch storage drive bracket, flex the bracket and align pin
pin
2
, pin
3
, and pin
Figure 84. Installing the storage converter with the new solid-state drive into the storage drive bracket
9. Install the storage converter with the bracket into the storage drive bay. See "Primary hard disk drive" on
page 91 or "Secondary hard disk drive" on page 93.
10. Connect the signal cable and the power cable to the solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
4
on the bracket with the corresponding holes in the storage converter.
.
Chapter 7
Hardware removal and installation
1
,
97
Advertisement
Table of Contents
