Table of Contents
Advertisement
Figure 79. Installing the solid-state drive into the storage converter
3. Remove the 3.5-inch storage drive bracket out of the chassis.
4. To install the storage converter into the 3.5-inch storage drive bracket, flex the bracket and align pin
pin
2
, pin
3
, and pin
Figure 80. Installing the storage converter together with the solid-state drive into the storage drive bracket
5. Install the storage converter with the bracket into the desired storage drive bay. See "Primary hard disk
drive" on page 91 or "Secondary hard disk drive" on page 93.
6. Connect the signal cable and the power cable to the solid-state drive.
4
on the bracket with the corresponding holes in the storage converter.
.
Chapter 7
Hardware removal and installation
1
,
95
Advertisement
Table of Contents
