Lexmark MX-B468F User Manual page 95

Use printer menus
Menu item
Date and Time
Configure
Current Date and Time
Manually Set Date and Time
Date Format (MM‑DD‑YYYY*)
Time Format (12 hour A.M./P.M.*)
Time Zone
UTC (GMT) Offset
DST Start
DST End
DST Offset
Network Time Protocol
Enable NTP (On*)
NTP Server
Enable Authentication (None*)
Key ID
Password
Paper Sizes
U.S.*
Metric
Screen Brightness
20–100% (100*)
Flash Drive Access
Disabled
Enabled*
Allow Background Removal
Off
On*
Allow Custom Job scans
Off
On*
One Page Flatbed Scanning
Off*
On
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Configure the printer date and time and network time protocol.
Notes:
•
MM‑DD‑YYYY is the U.S. factory default setting. DD-MM-
YYYY is the international factory default setting.
•
UTC (GMT) Offset, DST Start, DST End, and DST Offset
appear only when Time Zone is set to (UTC+user)
Custom.
•
Key ID and Password appear only when Enable
Authentication is set to MD5 key.
Specify the unit of measurement for paper sizes.
Note: The country or region selected in the initial setup
wizard determines the initial paper size setting.
Adjust the brightness of the display.
Enable access to the flash drive.
Specify whether background removal is allowed.
Specify whether the Custom Job Scanning setting appears for
copy, scan, and fax.
Note: This menu item appears only when a hard disk or an
intelligent storage drive is installed.
Set the printer to scan any type of job involving the scanner
glass as a single page.
Note: The printer returns to the home screen after
performing a single flatbed scan instead of displaying
prompts.
95