Carrier 50FC User Manual page 20

8 - TIME SCHEDULING
If it is desired to continue with the scheduled programme,
must be pressed with the terminal on the initial programming display
(TIME BAND).
The text SEL DAYS will then appear on the display to select the days
of the week to which the schedule will apply. With the
the following groups can be selected:
Complete week
Weekend
If it's desired to leave the programming, by pressing the
again, the terminal changes to the exit display (ESC), which is exited
by pressing .
If it is desired to continue with the schedule programming, the
key must be pressed on the screen of the days to which it applies
in order to access the fi rst time slot. The sequence of these slots
is as follows:
The fi rst time slot will fl icker on this display. If it desired to schedule
this slot, the key will be pressed and automatically stop
fl ickering, going on to appear as follows:
Next, with the key, the activation time of the program for
the selected slot will be set, and then, whether the unit will remain
stopped (OFF) or at the setpoint value.
Finally, the schedule slot will cease fl ickering. By pressing the
key, the scheduling created will be saved and the terminal will go
on to display the next slot.
20
keys,
Working days
Day to day
key
It will be necessary to defi ne a minimum of two slots for each day,
since only the initial time is established is established for each slot,
and not the ending time.
To delete the schedule from a time slot, it is necessary to select it
with the key, and then, by pressing the
time will be modifi ed until the display returns to show the following:
Note: Before making a new schedule, it must be checked whether
there is already one defi ned. If any schedule is made that may aff ect
another that is already stored, the latter will not be saved.
Activation of the schedule programming
By pressing the key for a short
time, the stored schedule programming
corresponding to the activation time is
activated.
The symbol and the active scheduling
slot will always appear on the main display,
both on stopped units and units in operation.
With the unit in operation, by pressing the
keys or the setpoint for the time
slot will be shown.
Note: The text will appear next to the
setpoint value.
To deactivate the schedule programming, it
is necessary only to press the
a short while.
The screen PH17 of the Graphic terminal (group L. SCHEDULE)
shows if the scheduler of the User terminal is active, the current
timeband and the temperature setpoint.
TCO Scheduler
Scheduler: OFF
Temp. setpoint: 26.0ßC
Scheduler OFF: NO
Current timeband: 0
keys, the
key for
PH17