Parameters That Are Stored In A Registration; Reverb And Other Settings - Roland VK-8M Owner's Manual

Advanced Use
Parameters That Are Stored
in a Registration

■ Reverb and Other Settings

1.
Hold down the [BANK] buttons, and press the [D
BEAM] button.
The indicators of buttons [1]–[2] will blink.
2.
Press one of the [1]–[2] buttons to select the parameter
that you want to edit.
There are two effect-related parameters.
The following parameters are assigned to each button.
Button Parameter
[1] REVERB TIME
[2] D BEAM ROTARY SPEED MODE
3.
Turn the [VIBRATO AND CHORUS] knob to adjust
the setting.
If you press the VIBRATO AND CHORUS [ON] button,
the setting will return to its initial value.
4.
If you want to edit another parameter, press the
appropriate button from [1] through [2] to select the
parameter, and turn the [VIBRATO AND CHORUS]
knob to adjust the setting.
When you want to stop editing, press the [BANK]
button.
5.
Press the [WRITE] button to finalize the settings of the
effect-related parameters.
6.
Save the finalized parameter settings in a registration
(p. 37).
NOTE
Never turn off the power while registration are being saved.
48
❍ REVERB TIME (0–127)
Adjusts the length of the Reverb time. Higher values
result in longer reverberation.
❍ D BEAM ROTARY SPEED MODE (SLOW/FAST,
CONTINUOUS)
Specify the D Beam function when ROTARY SPEED is
assigned to the D Beam.
Turn the [VIBRATO AND CHORUS] knob to the left to
select SLOW/FAST, or to the right to select
CONTINUOUS.
Setting
SLOW/FAST
Page
p. 48
p. 48
CONTINUOUS
NOTE
Never turn off the power while registration are being saved.
Explanation
The rotary effect is toggled between
slow and fast each time you move your
hand over the D Beam controller.
The rotary effect will change gradually
from slow to fast or fast to slow as you
move your hand closer to the D Beam
controller.