Making Xy Pad, D Beam, And Foot Pedal Settings - Roland CG-8 User Manual

Making XY pad, D Beam, and Foot Pedal settings

Here's how you can assign the Stamp Patch parameters that will be controlled by the
XY pad, D Beam, and foot pedal. You can independently make settings for the X-axis
and Y-axis of the XY pad, the left and right sensors of the D Beam, and for the foot
pedal. This lets you create patches that contain the most effective control settings for
each situation.
You can also assign the foot pedal to switch patches.
fig.front19.e.eps
fig.front20.e.eps
D Beam
1
Make sure that the [STAMP PATCH] pad is lit, and press the [CONTROLLER
ASSIGN] button.
The button will light, and the display panel will blink "–" in the Bank area.
fig.display01.eps
XY pad
[CONTROLLER ASSIGN]
button
[XY PAD ACTIVE]
indicator
[D-BEAM] indicators
Creating patches
For details on using the XY
pad, refer to "Using the
XY pad to apply effects
to the image" (p. 36). For
details on using the D
Beam, refer to "Using the
D Beam to apply effects
to the image" (p. 37). For
details on using the foot
pedal, refer to "Using a
foot pedal" (p. 44). For
details on the parameters
of the Stamp Effects, refer
to "Stamp Effects List"
(p. 119).
If you want to use the foot
pedal to switch patches, it
doesn't matter which pad
([PHOTO PATCH] or
[STAMP PATCH]) is lit;
either one will do.
You can't use the XY pad,
D Beam, or foot pedal to
control the depth of
modulation.
If you want to cancel this
operation after pressing
the [CONTROLLER
ASSIGN] button, press the
[EXIT] button.
79