Installation Of The Detector Head - Bosch AVENAR detector 4000 User Manual

AVENAR detector 4000
1 A / 30 V DC
a1/a2
(LSN -)
ye
wh
gn
NC/C/NO
+V/0 V
5.3

Installation of the detector head

Notice!
i
The packaging for the multisensor detector with C sensor consists of tear-proof PE-ALU
laminated film and must be cut open carefully.
After installation and connection of the base, the detector head is set into the base and turned
to the right as far as it will go.
Detector bases are delivered with an inactive locking clip.
To protect against removal, the detector head can be locked in the base. To do so, break the
locking clip (X) out of the base and push it into the corresponding guide.
1
X
X
Figure 5.1: Activation of locking clip
Bosch Sicherheitssysteme GmbH
NC NO
COM
NC C
NO
ye
wh
C
Yellow, connection to b1/b2 (LSN +)
White, connection to a1/a2 (LSN -)
Green, connection to shield wire
Change-over contact relay
Terminals for looping through the supply voltage for downstream elements
max. 30 V DC
b1 | b2
(LSN +)
ye
gn
2
X
User manual
Connection | en
3
X
2023-06 | 07 | F.01U.283.550
23