Photobeam 5000
3
Installation
Prior to installing the devices, please review the installation considerations below:
–
Install in an area that is clear of objects
–
Install the transmitter/receiver within the maximum protection range of the model
–
Do not install:
–
–
–
–
–
Do not use detectors with other photobeam detectors or receivers
–
Do not disassemble or modify this detector
–
Do not install while the power is on
–
Avoid extreme temperature and humidity ranges as defined in the products specifications
–
Avoid installing detectors near magnets and/or magnetized materials
–
Avoid beam interference between other units when multiple units are installed
–
Use the selectable beam's feature when stacking detectors
3.1
Beam spread
The beam spread angle is ±0.7 °from the transmitter to the receiver. Refer to the diagram and
table below to determine the installation conditions.
1
Figure 3.1: Beam distance and spread
Callout ﹘ Description
1 ー Transmitter
2 ー Horizontal spread (B)
3 ー Vertical spread (C)
Bosch Security Systems, Inc.
Receivers into intense sources of light (for example, rising and setting sun)
On movable surfaces subject to vibrations
Detectors where immersion to water, corrosive liquids, or exposure to high levels of
dust can occur
Detectors in close proximity to strong electromagnetic noises
Installation and Operation Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
5
Callout ﹘ Description
4 ー Receiver
5 ー Distance (A)
Installation | en
9
2
3
4
2016.02 | 03 | F.01U.303.478