Setting Films In The Holder (If Needed) - Ricoh Aficio 6110 Operating Instructions Manual

Preparing the Film

Setting Films in the Holder (If Needed)

Check which type of holder you should use.
Slide Holder/Glass Mount Film Holder
Note
The slide holder is covered with glass. Set the mount films in the slide holder.
The glass mount film holder is not covered with the glass. Set the glass mount films (covered by glass) in the glass
mount film holder.
Positive films are usually set in a slide mount or glass mount. If you use positive film not set in a mount, set it in the film
strip holder. See below.
1
Open the cover of the slide holder or glass mount
film holder, and set the slides in the holder one
by one.
Note
Set the front side of the film face down when setting
in the slide holder or glass mount film holder.
When setting in the slide holder, make sure that all
slides are aligned with the glass of the slide holder
cover.
2
Close the holder and lock it.
Film Strip Holder
Note
Negative film usually come in stripes.
Follow this procedure for positive strip film as well.
1
Open the film strip holder. Put the front side of
the film face down and set it in the film strip
holder.
Note
When setting film, leave the base film in the film strip
holder. This is convenient when performing shading
again.
2
Adjust the position of the film.
Note
Do not touch the image parts of the film when adjust-
ing.
3
Close the film strip holder and lock it .
218
See page 216.
1: Back
2: Front
TRSR0L0E
1
2
TRSR0K0E
TRSR0W0E