Mounting The Socket - Raymarine ST1000+ Owner's Handbook Manual

Chapter 4: Installing the Tiller Pilot

Mounting the socket

Install the tiller pilot socket as follows:
1. Attach the template (provided at the back of this handbook) to the selected
bulkhead.
2. Carefully drill a 21 mm (
3. Drill 4 pilot holes (2.5 mm or
4. Remove the template.
5. Pass the power cable and any other cables (SeaTalk and NMEA) through the
bulkhead and the gasket.
6. Use a small flat-bladed screwdriver to connect the cable(s) to the socket –
refer to the illustrations on the following pages to identify the individual con-
nections on the SeaTalk socket. Ensure that the socket is oriented correctly
and note the connection numbers in relation to the keyway..
Socket
Gasket
Cable
Rubber cap
53
Floating nut
Plug
Screw
/ in) clearance hole for the cable boss.
64
3
/ in) for the self-tapping screws.
32
Retaining ring
Installed socket
D3296-2
41