Table of Contents
Advertisement
Chapter 4: Installing the Tiller Pilot
Basic installation
After establishing control dimensions A and B, you can usually mount the tiller
pilot directly onto the cockpit seat.
Installing the tiller pin
1. Drill a 6 mm (
you have marked on the tiller.
2. Use a two part epoxy (e.g. Araldite) to fix the tiller pin in place.
3. Position the shoulder of the pin so it is 12.5 mm (
Installing the mounting socket
1. Drill a 12.5 mm (
have marked on the cockpit seat.
2. If the structure at the mounting position is less than 25 mm (1 in) thick, rein-
force the underside with plywood bonded into position.
3. Fix the mounting socket in place using a two part epoxy.
Mounting socket
1
/
in) diameter hole to a depth of 25 mm (1 in) at the fixing point
4
1
/
in) hole to a depth of 25 mm (1 in) at the fixing point you
2
12.5 mm
(0.5 in)
Tiller pin
D3192-2
1
/
in) above the tiller surface.
2
33
Hide quick links:
Advertisement
Table of Contents
