Chapter 4: Installing the Tiller Pilot
4.3 Cabling and socket installation
Both power and data are supplied to the tiller pilot via a waterproof
plug and socket. The plug comes ready assembled and the socket can
be mounted in the cockpit area adjacent to the tiller pilot.
Mounting the socket
Install the tiller pilot socket as follows:
1. Attach the template (provided at the back of this handbook) to the
2. Carefully drill a 21 mm (
3. Drill 4 pilot holes (2.5 mm or
+12 V DC (brown, pin 1)
0 V (blue, pin 2)
Socket
Gasket
Cable
Rubber cap
selected bulkhead.
NMEA + (white, pin 6)
NMEA - (green, pin 5)
SeaTalk data (yellow, pin 4)
Floating nut
Plug
Screw
53
/
in) clearance hole for the cable boss.
64
3
/
in) for the self-tapping screws.
32
45
D305-3
Retaining ring
Installed socket
D3296-2