System Settings - Ricoh PT3 Field Service Manual

6. Appendix: Service Program Mode Tables
Default: 2 mm
SP2-80: Auto off at Unusual Voltage
There is an automatic detection system for unexpected voltage surges, featuring automatic shut-off and
data logging features.
SP2-95: Paper Table Standby Position.
High: The paper table after printing is moved to a higher position than the standard position. This will reduce
the time for starting the first print when continuously making masters.
Low: The standard position
• If SP2-95 is "high", the machine goes to the standard position in the following situations.
• When the master end indicator lights and a message is displayed
• When a master eject jam (B jam location indicator) is displayed
• When a master feed jam (D jam location indicator) is displayed
• When the paper height sensor is actuated immediately after the main switch is turned on.
6
SP2-100: Make master without print
This function wraps a blank master around the drum. The ink on the drum may dry up at the following times:
• The machine is not used for a long time.
• The customer changes to a color drum that has not been used recently.
This might affect the print quality (Poor image: ghost image of the previous print).
Wrap a blank master around the drum after you print, to prevent ghost images of previous prints when the
machine is not used for a long time.
Procedure:
1. Access SP2-100 (Make master without printing). Then press "OK".
2. Press the "Start" key while holding down the "#" key.

3. System Settings

SP Table (SP 3-xxx)
No.
1 Input the present time
2 Input TEL number
3 Input serial number
32
Menu Items Default
(00/01/01 0:00) 99/12/31 23:59
-
-
Settings