Memory Clear - Ricoh PT3 Field Service Manual

6. Appendix: Service Program Mode Tables
1st print: 60 rpm
2nd print: 80 rpm
3rd print: 100 rpm
4th print: 130 rpm
3. The distance between the leading edge and first line should be 8mm, as shown below.
6
4. If this distance is not 8mm, access SP6-101 to 104 and then input a value to adjust the distance
(range: -40 to 40, step: 1) for each of 3 copies samples (i.e. 30, 60, 80, 100 and 130 rpm samples).
The higher the value, the narrower the distance between the leading edge and 1st line becomes (and
vice-versa). Also, each step corresponds to approximately 0.5mm. Input the value that will bring the
distance to 8mm.
5. Perform the adjustment again for any of the samples that are still outside the 8mm standard.
• Adjust SP6-108 to 112, 132 to 144 in the same way.

7. Memory Clear

SP Table (SP 7-xxx)
No.
1 Factory settings clear
3 Total counter clear
4 Jam/Error data clear
44
Menu Items