Ricoh PT3 Field Service Manual page 44

2. Installation
2
6. Open the master eject unit.
7. Install the auxiliary bracket [E] on the tape dispenser with M4x8 screws (accessories) [F].
8. Install the tape dispenser on the main body with two M4x8 screws [G] (accessories) in the two outer
holes in the tape dispenser bracket.
9. Close the master eject unit. Reinstall the paper delivery cover.
10. Open the tape dispenser cover [H]. Then, insert the leading edge of the tape into the tape entrance
until it stops as shown in the illustration [I].
• Be sure that the tape is installed in the proper direction. If it is not, the tape dispenser will not
work correctly.
42