66
Note: If the deviation value exceeds 15° or a deviation value is not
displayed at all, you should consider moving the fluxgate compass to a
better location.
7. Press the disp key to move on to the Heading Alignment page.
8. Use the +1 and +1, keys, or the +10 and -10 keys, to increase or
9. Press and hold standby for 2 seconds to exit calibration and save
Note: Setup options are always saved on exit.
This shows the maximum deviation detected, and indicates that
compass correction has been completed successfully.
ALIGN HDG
decrease the displayed heading, until it agrees with the ship's
steering compass or a known transit bearing.
the new settings.
ST5000 Plus SailPilot Owner's Handbook
D3458-1
D3459-1