Moving The Cooker - Rangemaster Excel 110 Ceramic Users Manual & Installation

Moving the Cooker

The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure
that the floor covering is firmly fixed, or removed to prevent
it being disturbed when moving the cooker around. You will
need the levelling tool.
Pull the warmer drawer out to its furthest point.
Lift it up and out.
Fit the levelling tool on the rectangular adjuster as shown
below.
LOWER THE FRONT ROLLER by doing 14 complete (360°)
turns clockwise. (This means turning and removing the
levelling tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut as
shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Carefully push the cooker backwards close to its final
position leaving just enough space to get behind it. Take
care not to damage the power cable.
Do not use the door handles or control knobs to manoeuvre
the cooker. Remove the pack base tray.
Levelling
You are recommended to use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker. Turn
clockwise to raise the cooker and anticlockwise to lower.
When you are satisfied with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the floor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the
front roller, to prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle
of the tool facing the rear of the cooker, so that the
customer can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push in.
26