Using The Lan Interface - Inmarsat EXPLORER 500 User Manual

Using the LAN interface

Before connecting to the LAN interface
To connect to the LAN (Local Area Network) interface, use a shielded cable mounted with an RJ-45
connector.
The LAN interface is configured as MDI-X. This means that if you are connecting your computer
directly to the EXPLORER 500, you should use a straight cable. If you are connecting a switch to
the EXPLORER 500, use a crossed cable.
For specifications, refer to LAN interface on page 155.
For the LAN interface to work without any further setup, the computer must be set up to obtain an
IP address and a DNS server address automatically.
To check these settings on your computer, do as follows (For Windows XP):
1. Select Connect To > Show All Connections from the Start menu.
2. Double-click Local Area Connection.
3. Click Properties
4. Select Internet Protocol (TCP/IP) from the list and click Properties.
Make sure both fields are set to obtain an address automatically.
TT 98-122274-O Using a computer
Chapter 4: Using the interfaces
65