Uploading Software; Maintenance - Inmarsat EXPLORER 500 User Manual

Uploading software

Viewing software version status
To view the version of the embedded software in the EXPLORER 500, select PROPERTIES in the
web interface or in the display menus and see Software information.
Uploading software using the web interface
You can upload software from the PROPERTIES > Upload window in the web interface.
If you have an Administrator user name and password you do not need to insert a SIM card nor to
enter the PIN to be able to upload software.
For further information, see Uploading software on page 120.

Maintenance

Normal use of the battery
It is recommended not to partially charge/discharge the battery several times in a row. Partial
charging/discharging affects the accuracy of the capacity measurement.
Never leave the battery fully discharged for a longer period of time. If the battery is not to be used
for a shorter period of time (1 month), charge the battery to minimum 20 to 30% and remove it
from the EXPLORER 500. If the Battery is stored for more than a month, see Storage at the end of
this section.
Recharging the battery
To recharge the battery, insert it into the EXPLORER 500 and connect the EXPLORER 500 to power.
The indicator left to the display is constantly green as long as the battery is charging. When the
battery is fully recharged, the green indicator is turned off. If the EXPLORER 500 is switched on,
the green indicator will be flashing shortly every 2 seconds.
If a charging error occurs, the green indicator on the EXPLORER 500 flashes rapidly. See the
Troubleshooting Guide on page 138.
TT 98-122274-O
Chapter 6: Maintenance and troubleshooting
135