EverFocus EMN Series User Manual page 63

PASV mode: Check the box to enable Passive mode. Passive mode is normally enabled. If a

connection cannot be established, uncheck "PASV Mode".
Test FTP Server: Click the Test button to send a testing file to the assigned FTP server.

Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
【SNMP Settings】 The default values for SNMP v1/v2/v2c and SNMP v3 are already filled in. Click either
of the Enable buttons to enable either of the two. Make your changes as desired. Click on the Trap
Address field to enter the digits, if required.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
【Network Alarm Settings】This function works with EverFocus CMS software. The camera can send a
network alarm signal (when the event occurs) to the CMS servers. To establish the connection
between the camera and CMS servers, the protocol and port number should match with each other.
For more details, please refer to the CMS user's manual. Note that to enable the Network Alarm
function, you have to check the Network Alarm box in the Event Management field (see 7.3.2
Event).
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
EMN Series Mini Mobile IP Dome
57