EverFocus EMN Series User Manual page 60

Event + Schedule (Yellow): Select for the camera to active both of the configured Event and

Schedule Recordings.
Deselect (Grey): Select for the camera to stop recording.

Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
【Motion Settings】 Use this page to configure up to four areas in which motion will be detected. When
a motion is detected by the camera, the motion detection icon
right corner on the Live page to alert the user. This function can also be linked with correctly
configured Events to trigger Event reactions like the activation of video recording periods, snapshots,
etc.
To set up the Motion area:
1. Check the Enable box to enable the selected area.
2. Select a sensitivity value of the motion detection sensor function.
3. Click the Draw button
4. Move the cursor to the position where you want the motion rectangle to start and then click.
Move the cursor to the position (diagonally opposing corner) where you want the motion
rectangle to end and then click.
5. Click the Apply button to apply the settings, or click the Cancel button to reset without saving
the settings.
and move the cursor on the left-side live image.
54
EMN Series Mini Mobile IP Dome
will appear at the top