Platform Controls; Platform Circuit Board - Terex Genie SX -180 Service And Repair Manual

December 2018
Part No. 1268497
1-1

Platform Circuit Board

Note: When the platform circuit board is replaced,
the joystick controllers will need to be calibrated.
Refer to Repair Procedure, How to Calibrate a
Joystick.
How to Remove the Circuit Board
1 Push in the red Emergency Stop button to the
off position at both the ground and platform
controls.
2 Locate the cables that connect to the bottom of
the control box. Number each cable and its
location at the control box.
3 Disconnect the cables from the bottom of the
platform control box.
4 Remove the control cable receptacle retaining
fasteners from the bottom of the platform
control box.
5 Remove the platform control box lid retaining
fasteners. Open the control box lid.
6 Locate the circuit board mounted to the inside
of the platform control box.
SX-180
Service and Repair Manual

Platform Controls

Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
19