EAW QX Series Application Manual page 90

Passive Point Source
6. Review the MKC Series Loudspeaker installation
a. Confirm the loudspeaker is level or plumb depending on the configuration.
b. Confirm the aim angle is as expected.
c. Confirm all hardware is tight.
7. Maintenance of an MKC Series Brackets installation
a. WARNING: Not following Maintenance instructions could result in equipment
damage, serious injury or death.
b. Maintenance should only be performed by an experienced technician.
c. As with any professional loudspeaker system, routine maintenance must be conducted in
order to ensure the longevity and safe, consistent performance.
d. Inspect the MKC Series Brackets for damage. Brackets with visible damage should be
replaced and discarded.
e. Inspect hardware securing the bracket to the mounting surface for corrosion or
looseness. Tighten loose hardware and consider installing hardware locking methods.
Replace and discard corroded hardware.
f. Inspect hardware mounting the MKC Series loudspeaker to the brackets for corrosion or
looseness. Tighten loose hardware. Replace and discard corroded hardware.
g. Clean the MKC Series Brackets and MKC Series loudspeakers with a dry cloth.
Application Guide
i. Loosen bolt and nut locking the current angle
on the Pivot Block in place using (2) 10mm
wrenches (see image on previous page)
ii. The lock pin will work in increments of 5
degrees (See left image). Set desired
10°,25° 10°,25°
rotate or tilt angle for pivot block.
20°,15°,30° 20°,15°,30°
iii. Loosen Button Head Hex Drive Screw
5°,20° 5°,20°
connecting wall and cabinet bracket using a
6mm allen wrench
iv. Once desired pan or tilt angle is achieved,
fully tighten the bolt.
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
90